AQ gold cooler O rings?

[T.S.Davis]

Anybody know where to get them?

Shredded one installing it. Never had this much trouble getting one on before.

[Jlov]

I shredded both of mine trying to install them....feel your pain! Ive been looking for a few days trying to find them myself. Might just have to buy jacket again as it was only $6!

[martin]

Dosnt help with replacing the shredded rings but Properchopper on the forum sanded a bevel on the end cap of his Aqu motor because of this very problem. He had some pics of his mod.

[egneg]

Here are some ... http://www.offshoreelectrics.com/pro...rod=ose-orings

[martin]

Also to aid fitting jacket to either tight fits or square edge end caps I make a disc the diameter of my motors end cap & around 3mm thick with a hole in the centre & slide it onto the end cap & secure it to the end cap with the 2 mounting screws. The disc or washer has a taper to it edge making sliding jackets on a breeze & simply remove the screws & disc once the jacket is fitted. This also works a treat where you have motor end caps that have sharp corners where some end caps have counter bored holes machined for screw heads to sit in that can tear o rings to shreds.

[properchopper]

Dosnt help with replacing the shredded rings but Properchopper on the forum sanded a bevel on the end cap of his Aqu motor because of this very problem. He had some pics of his mod.

See post #8. So far has worked bueno for the last two motors I tried this on. Goodbye to "Shredded O-Ring" breakfast cereal.

http://forums.offshoreelectrics.com/...a-water-jacket.

[T.S.Davis]

Wish they were all built like this one.
http://www.offshoreelectrics.com/pro...Neu2215-jacket

By the time I get done running around town to find an O ring I could have bought another jacket. There $7. I'm in the local hobby at least twice a week lately. Realllllyyy annoying.