Hydromarine XRay Low-Profile

[webdesaster]

Hello,

I just got a new project in mind and having some experience in high speed catamarans (Hydromarine Maritmo twin -> 150km/h) I am quite new to monos. I want to build up an Hydromarine Xray lowprofile hull. The hull is about 124cm long and I have some hardware left: 2 Neu 1512 2050kv, 2 Turingy 180A, 2 6S 5000mAh, 90mm Stingers and R+L octura x442.

So I want to know your experience in twin config monos, and what do you think about using this hardware in that hull?

Greetz, Claude

[photohoward1]

Kind of a Big Boat for even (2) 1512 Motors. Thats a four foot boat. I would run it on a single 1527 the smallest. maybe even a 2230...on 10 cells. (My Choice)
Dual Choice (2) 1527/1D... It's going to be heavy. Great looking boat though.

[webdesaster]

Thanks for your answer :)

This setup I wrote about is the setup I used in my maritmo to break the 150 km/h, so if possible I want to keep it.

but my wish is to build up a mono on twin setup, I just love the look and the sound of a twin as well as the better stability, so I'm going to ask the question in a different way: what mono hull (deep vee) would you take for that setup?

Greetz, Claude

[axel]

Well Claude
1.what is your goal by the Mono?
2.If you want to use the Stingers you are limited to max. 1meter and the props are for a boat more than 1meter way to small.

my 2cents
Axel

[webdesaster]

My goal is to have a mono that gets a nice speed and has a nice handling and for which I don't need a huge waterplan to navigate with.

That's what I thought too about the props, but I'm worried about to put bigger props on these motors in a bigger mono hull. On my maritmo with these motor I ran X447 without any problem, but monos need more amps, no?