Newbie Prop Question

[Jc03]

I just purchased a sharpened m445 for my new Revolt 30 and don't want to break anything while changing the prop. Does anyone have any advice? I figure you just put a wrench on one of the nuts closer to the motor and then ratchet off the prop nut?

[Fluid]

Most will grab the prop with a rag and apply the wrench to the prop nut. Your method will tend to unravel the cable over time.

[gixx1k2]

you should be able to just hold the prop with a towel in your hand, and loosen the nut.

[Jc03]

Thanks. I appreciate it. I hadn't really looked at the prop and didn't think about the "slot" on the backside that will hold everything in place.

[grsboats]

And as you stated a sharpened prop take care with your fingers to loose the nut too.Gill