trim tabs for traxxas spartan

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Zackthrills
    Senior Member
    • Apr 2013
    • 305

    #1

    trim tabs for traxxas spartan

    I know that there are a lot of trim tab out there. I would like to know besides putting on the factory ones on my phone for putting its just a bowl 1 what is the difference with ones that might be a little bit bigger or should I say why they would that help to give my boss a little bit more stability if I put them in towards the keel and having less wider ones on the outside when I'm looking to go for just speed. Any help on trim tab adjustment would be great and the difference on why some are wide and some not so wide and what is the benefit
  • Rumdog
    Fast Electric Addict!
    • Mar 2009
    • 6453

    #2
    wide will work a bit in straights, and in turns. for straight line speed runs only, tabs closer to the strut will work best.
    Also, please use some form of spellcheck. Not being an A$$, but a lot of your posts are hard to read.

    Comment

    • Zackthrills
      Senior Member
      • Apr 2013
      • 305

      #3
      Sorry Ya work allot and short min at best to post. And the phone speak to text sucks

      Comment

      • Zackthrills
        Senior Member
        • Apr 2013
        • 305

        #4
        You know this timing crap had me all messed up. I read the bad it says to set at 18.75º then some day it needs to be at 3.75º which is it? Why lower why higher please explain

        Comment

        • Speedracer128
          Senior Member
          • Apr 2013
          • 288

          #5
          Haha rumdog. I always think the same thing when I read his posts while I'm deciphering what hell he's talking about
          Last edited by Speedracer128; 07-12-2013, 10:30 AM.

          Comment

          • Zackthrills
            Senior Member
            • Apr 2013
            • 305

            #6
            Sorry I'll take the time to read it before I post my fault

            Comment

            Working...