What kind of glue for shaft enetering the hull

[paultbg]

Hello
I have seen some very nice works to some members here.
What kind of glue do you use to hold the shaft in position where it enter the hull (inside/ outside)?
Maybe you can post some pictures? Or if there is a post already done can you show me the link?
Many thanks

[kevinlew211]

epoxy

[JimClark]

Epoxy with a thicker is what I use

[TheShaughnessy]

http://forums.offshoreelectrics.com/...at-RCBOATBUILD

Look at post 21. He uses jb weld. CA glue is used to tack the O ring in place and then fill it with jb weld. Tape is used to mask the bottom off

[grsboats]

with long cure epoxy(30min - two hour) you can't go wrong but take care to mix equall parts according the manufacturer.Gill

[LiPo Power]

Jb weld ....

[twissted]

This is what I used in my first build 30 min 2 part epoxy. I could see jb weld as a really good weld as well
I like the epoxy as it is clear and is easer to wipe and clean.