Question about setting failsafes

[bob_t]

I'm going to change the ESC on my MG29 to another (higher amperage) PB ESC. I don't see anything about setting the failsafes in the ESC instructions, so I assume that as long as I don't change the radio (transmitter and receiver), I do not need to reset the failsafes, correct? Just simply remove and replace, (and get the wires from the ESC to the correct connectors on the motor), right? I have the programming card and will set the ESC to what I need, once it is installed.

Thanks,
Bob

[oscarel]

Failsafe is between transmitter and receiver. See page 6 of manual. http://www.proboatmodels.com/ProdInf..._manual_EN.pdf

[bob_t]

Thanks. V2 manual is much better than V1 manual ... don't remember seeing that in the V1 manual (but it has been a while). I thought it was better to ask than have another "unexpected event" ... have enough of them already.
Thanks!