Tweet
My 300 amp 3-16s Fightercat speed controller has a heat sink for the back of the circuit board. Between the board and the grease is a thin tape or plastic, presumably for electrical isolation while still allowing heat transfer. Does anyone know where I can get some of this stuff?
-
Fast Electrics Have A Small Carbon Wake
-
This is what I have found so far and am very tempted to order http://cpc.farnell.com/electrolube/t...und/dp/SA01013 .Could be very handy. Usually the local electronics shops will have heat sink compound but it does not harden.Most of these ESC's need something to bond the heat sinks.I recently had a Castle lose it bond when I hit it with Conformal Coating. -
Ebay, put in heat sink pads, heat sink tape, thermal heat transfer pads. Lots of it on their.Comment
-
That's not what I'm looking for. This stuff is about the thickness of scotch tape. If I can't find any that's probably what I'll do, though.Fast Electrics Have A Small Carbon Wake
Comment
-
This may work http://www.itapestore.com/3mthermall...0heatsink.aspx"There's nothing else I really want to do other than get up and build boats." - Mike FioreComment
-
Digikey.com, products, fans/thermal management, thermal - pads, sheets.
choose your poisonLast edited by Basstronics; 11-20-2012, 06:47 PM.42" Osprey, 32" Pursuit, 26" Bling Rocket (rescue), Blizzard Rigger, JAE 21FE rigger, Hobby King rigger (RIP)Comment
-
Good stuff here.Comment
-
Some are single side or double side adhesive also.42" Osprey, 32" Pursuit, 26" Bling Rocket (rescue), Blizzard Rigger, JAE 21FE rigger, Hobby King rigger (RIP)Comment
-
s this the lander motor? If so could you weight it for me...I would LOVE to know the mass on the motor...seems like the SUPPO 910kv would be a direct replacement for it.
Fightercat RC has them for 55shippedComment
-
lots of different types on ebay"Our society strives to avoid any possibility of offending anyone except God.
Billy GrahamComment
-
The best place to get kapton tape is dealextreme.com
MarkComment
-
100 mph mono
the mono you ran the neu 2230 in . what size and length flex cable did you run in that boat? how much did it weigh? thanksComment
-
I ran a 1/4 cable. Don't know lengths or weight. My motor was towards the front of the boat so I think my cable was over 1 ft long.
MarkComment
-
So Mark F, the kapton tape has high thermal conductivity and good electrical insulating properties, correct? And by the way, those 6s 5000 mah batts work great in the mono. Thanks- MikeFast Electrics Have A Small Carbon Wake
Comment
Comment