Help Needed On A Mono Setup

[Gary Mullens]

I have a 26" mono I am setting up and need help on the drive setup. Below are the links I think will work on the boat. What stinger or strut setup would I need to get?

http://www.offshoreelectrics.com/pro...?prod=ose-1075

http://www.offshoreelectrics.com/pro...=ros-spdsd-187

Here is the motor or one similar to it...
http://www.hobbyking.com/hobbycity/s...hless_Inrunner

Let me know what you think on this set up. Also, Here are the props I'm looking at.

X435, X632 X432.

Thanks,
-Gary

[dana]

The cable you posted is stepped down to 1/8 propshaft. Given that a majority of props have 3/16 bore, you would need to put a sleeve on any props you use. Go with a full 3/16 shaft. Which hull is it?

[Gary Mullens]

Thanks for the feedback. It's a scaled down wildthing hull that I built. The 1/8 bore props won't work?
What about a stinger drive?

[dana]

Well are the props you mentioned 1/8 bore? You can use a stinger or a strut, up to you really.

[dana]

I'm thinking the props you mentioned might be a tad small. I run a x440/3 on my Df 26

[Gary Mullens]

Thanks, I really like the idea of the stinger though. I'm fairly new to this type of setup and need some guidance on what to
buy. I don't want to buy twice, except for breaking something. LOL

[dana]

Well you can always get the cable you posted, then just grab a 3/16 shaft cable if you choose later on. Nothing wrong with the stuff you posted

[Gary Mullens]

Thanks Dana! Here is a vid with the setup I am interested in. This boat has the exact same setup.

http://www.youtube.com/watch?v=L89uFditprg

[dana]

Looks rippin man.

[dana]

the sm 3/16 adjustable stinger would be good http://kintecracing.com/Hardware.html

[Gary Mullens]

I was going to ask you what you would recommend. So the components I listed will fit together with this stinger?
Thanks,
-Gary

[dana]

yes

[Gary Mullens]

Which one of the Stingers should I get? The stuffing tube goes into and through the stinger?

[dana]

although, i would probably go with this bushing instead. not sure if the bushing you posted is only compatable with speedmaster stingers http://www.offshoreelectrics.com/pro...s-spds-014-bsf

[Gary Mullens]

I'll be on again tomorrow, off to bed.
Thanks again Dana!