Tweet
Anyone have any experience with these ESC's. What is the 4 wire connector for? Data logger maybe? Programming box? These ESC's seem to be awesome except they have no instructions what so ever. That's the only downfall I've found.
-
-
It should come with a pink instruction sheet. The FC ESC is very easy to use, especially with the programmer. Leave the 4 Wire connector alone, it isn't for the consumer. If you haven't purchase the handheld programmer it'll be a good investment and makes life easier, works with all fightercat esc. I have 3 FC ESC and they perform very well. -
I ran one with the BEC and it smoked, the amperage output of it is not enough for a high torque servo acoording to Ben. He sent me a new 200a 16s as a replacement. Run an RX pack.NEED PARALLEL CONNECTORS?? QUALITY 5.5MM, 8MM, 8 AND 10 AWG, GET THEM HERE:
http://forums.offshoreelectrics.com/...est!&highlight=Comment
-
Yes I have an RX batt tray already built in. 6V 1600 mah I'm running one HV 130oz metal gear low profile servo. But thinking of adding a second rudder and servo for a dual steering setup. so def. need the Rx batt. So to use the Rx battery I just remove the + lead on the ESC Rx wire?Comment
-
Yep, the center lead.NEED PARALLEL CONNECTORS?? QUALITY 5.5MM, 8MM, 8 AND 10 AWG, GET THEM HERE: http://forums.offshoreelectrics.com/...est!&highlight=Comment
-
ESC Programming using the Program Box.doc
The 4 wire plug is for Firmware updating only.
and above all, get the program box.
Above are the instructions I originally did for Ben.
MAKE SURE AND DO THE PROGRAMMING WITH A 3S PACK. (THINGS will warm up
very quickly is you use higher voltages for programming.) Just a safety thing is all folks.
they are available in German and also Italian and I believe in French as well.Comment
-
where can u buy the fighter cat esc's???????Comment
-
they only ones available from FC Racing are the low voltage ESC's now.
Comment
Comment