Help and Advice with a New Setup

[offshore racer]

Hello. I have an old boat hull that basically needs shafts couplers drive dogs and props. The boat is a V hull 25" long and about 9.5" wide at the widest point. I was wanting to run flex shafts but whatever you recommend would be fine as I would just like a complete setup. Both shafts are fully submerged and go down at about a 30 degree angle. I plan to mount a center rudder. The power setup will be straight out of a villain ex, two counter rotating 550 motors on two 6 cell NiMh packs. I am looking for a full prop and shaft setup. Thanks,

[ozzie-crawl]

I would buy another hull. Submerged drive will give you very limited performance.

[offshore racer]

I would buy another hull. Submerged drive will give you very limited performance.

I know but the hull has sentimental value. The project is meant as a surprise gift.