Going crazy with my esc

[paultbg]

I have a problem (another one) with my seaking 120A.
When I push the throttle the motor is starting ok, full power and then in 5-10 seconds is slowly stopping.
I run 2 x 2s lipo, charged.
I have never experienced this before.
Tried with different tx/rx and with separate bec and esc' bec, the same.
Please advise me otherwise i am going nuts...
Regards

[Chuck E Cheese]

try a different set of batteries or turning the lvc off. it sounds sounds like you are hitting the low voltage cut off.... does it start back up after slowing?

[G-UNIT]

I agree with chuck e cheese.

[paultbg]

I agree with chuck e cheese.

I agree too because that was the problem.Many thanks guys for the help.
I have disabled the LVC and now is ok.However I am wondering why suddenly the LVC changed itself....

[Chuck E Cheese]

it is probablly your batteries that changed, not the lvc.... it should be ok if you set it at 2.7v or so, i on the other hand never use lvc. i time my runs and pre-set the timer on my transmitter to each boat after experiments so that i know how much run time i can get on each boat/batt set-up.
glad we could help!

[G-UNIT]

Hey Chuck E Cheese, not to get off the thread but what kind of tx are you running ? I am not up on transmitters and don't know alot about them like one might have say 20 memorie settings, what does that actually mean?