powering a Delta force 35 suggestions.

[ozzie-crawl]

Contemplating on getting back in to boats. moving state and finally going to have a big fresh water dam to run on.
been awhile so looking at power suggestions for a DF 35 would like 60 mph (sub 2 min runs) if thats reasonable ?.
6s ?
Nue 1515 1.5y (1500kv) think to small ?
Nue 1521 1y (1575kv) to much rpm ?

Would a T180 esc be enough ?

any thought suggestions much appreciated

Ozzie

[srislash]

Well here's mine with a 1717 http://forums.offshoreelectrics.com/...ork&highlight=

And the vid http://www.youtube.com/watch?v=to30E...=youtube_gdata
It is pushing 60

[Make-a-Wake]

This motor in the 1390kv should move you right to 60 or so...................need to play with prop...........452, 646 etc.............

http://www.offshoreelectrics.com/pro...o-4092&cat=148

[srislash]

A 4092 should do the trick.The 1717's are hard to find and the mount is harder.Though I think Brushless55 still has one.

[ozzie-crawl]

Thanks slash will go threw your thread.
Do the leopards hold up ok, they were fairly new and a sorta a untested motor when i stopped boating

[Make-a-Wake]

They are well tested and well liked now Ozzie...................I betcha 3/4 of folks on this forum have at least one.

[ozzie-crawl]

Thanks Make a wake.
when i ran boats before i had decent results with some cheaper gear,thinking 1 boat but good motor/esc combo would be nice

[ozzie-crawl]

Hmm "one boat" laughs to self

[ozzie-crawl]

just realized slash your mono is 45" and i am looking at a 35"

[detox]

Seems everyone forgets this Castle Creations chart.

[martin]

Steven Vaccaro has recently tested a Leopard 4092 motor on 6s in a 36" cat hull & got 67mph.

[drwayne]

Contemplating on getting back in to boats. moving state

Ozzie

Where to, Scott ?

[ozzie-crawl]

probably a little town called Cowra by the looks of it. 200klm north of Canberra and 200klm south of Dubbo
and around 35-40 klmh from a Dam