motor suggestions

[h2o 1]

I was referring to dana's comment about the 4082....... but..... you answered my question,so thanks!

[Make-a-Wake]

Hey Camaro, what about this 4082 for $80? I have a 4074 and like it just fine.

http://forums.offshoreelectrics.com/...-TP4082-2180kv

[dana]

There's a good one...that motor, With a m445 you'll be into the 50's

[camarohrod]

Will it fit in my motor mount that I already have and will the piece that holds the flex shaft to the motor fit it also?

[Make-a-Wake]

You dont have a tail ring on your mount do you? If not It will work............... The collet will work if the shafts are both 5mm on the motors which i believe they are

[jamespl]

ImageUploadedByTapatalk1333865185.042049.jpgHere is a pic of my genesis with the turnigy xk-4074 2000kv motor in the stock mount, all I've done is get the 40mm mount to hold the top en of the motor secure the rest is as it came inc the collet hope this helps.



---
I am here: http://tapatalk.com/map.php?1jrupv

[camarohrod]

You dont have a tail ring on your mount do you? If not It will work............... The collet will work if the shafts are both 5mm on the motors which i believe they are

i do have a tail ring on my setup right now, is the motor goin to be the same size to fit in that ring?

[Make-a-Wake]

i do have a tail ring on my setup right now, is the motor goin to be the same size to fit in that ring?

No, its 40mm diameter as opposed to 36..................see if you can buy a 40mm tail ring like James did.

[srislash]

[ATTACH]73989[/ATTACH]Here is a pic of my genesis with the turnigy xk-4074 2000kv motor in the stock mount, all I've done is get the 40mm mount to hold the top en of the motor secure the rest is as it came inc the collet hope this helps.



---
I am here: http://tapatalk.com/map.php?1jrupv

Where did you get the white cooling tube?I have a particular use for it.

[dana]

you can either buy a 40mm mount for 20 bux and steal the tailring, or find someone with a spare to sell you, or, you could just go with no tailring and wedge a piece of wood or something under the back of the motor to carry some of the weight. the motor should bolt onto the front of your mount just fine. its the tailring in back that comes in different sizes. you have 36mm. you need 40mm