is this Aeromarine SprintCat 36???? need advice on motor and prop

[aminoacid]

Hi guys I got this cat and not sure but I think its an aeromarine sprintcat 36?? can anybody confirm? measures about 35 inches or so from sponsoon tip to transom. Its a nitro for sure though.

Can anybody recommend a low budget motor and prop for this?

pics are posted.
boat is 14 inches wide. 35 long and weighs 7 lbs 5oz.

[Serpents811]

Hi guys I got this cat and not sure but I think its an aeromarine sprintcat 36?? can anybody confirm? measures about 35 inches or so from sponsoon tip to transom. Its a nitro for sure though.

Can anybody recommend a low budget motor and prop for this?

pics are posted.
boat is 14 inches wide. 35 long and weighs 7 lbs 5oz.

usually aeromarine hulls got their label inside , as far as motor goes , are you running twin or single , if twin dual 3674 2200kv 4s2p or a single 4074 1400kv 6s2p

[aminoacid]

Single motor for sure

[Serpents811]

Single motor for sure

leopard 4074 1400kv on 6s and let her rip

[aminoacid]

What about prop?

[Serpents811]

What about prop?

maybe m445 or x447 and check your temps

[aminoacid]

another quesion perhaps you can shed some light, how can i convert the motor mount from this nitro to brushless?

[Serpents811]

another quesion perhaps you can shed some light, how can i convert the motor mount from this nitro to brushless?

you are going to do some handy work on that one , you are going to need either everything off the hull or work around it

[aminoacid]

how does this compare to the leopard? considering its half the price?

TURNIGY 4074

[Serpents811]

how does this compare to the leopard? considering its half the price?

TURNIGY 4074

If you check leapord specs they are rated at 2000watts and the leopard 4074 1400kv could handle I think up to 32volts vs. 22.2 on the turnigy

[Rumdog]

4074 is waaay too small.

[Serpents811]

4074 is waaay too small.

That's what thought more like a 4082 or 4092 range

[srislash]

another quesion perhaps you can shed some light, how can i convert the motor mount from this nitro to brushless?

Is there room for this http://www.offshoreelectrics.com/pro...prod=ose-80600 or you could run one of Punisher's mounts that fit 4" rails.
BTW That's a really nice looking boat.

[Serpents811]

Most deff 4082 1450kv in 6s to keep it mild or 4092 1390 8s+

[Rumdog]

Williams racing makes inexpensive rail mounts. I'd go at least a 4092 Leopard.