Trying to convert a brushed motor boat to a brushless. It is a 7 year old plastic hull called the Super Hawaii which was a champion offshore boat. Boat is 36 inches long and 8.5 inches wide. The problem is once it hits 25 mph it becomes unstable, goes into a death woble and tries to come out of the water. Tried several things but no improvement.
Here are the details:
Pro Boat 1500 kv motor.
Tried M445 and P220 props.
Trim tabs are 1.5 inches. Settings from level with hull to 1/8 inch down.
It is a deep V hull.
Batteries: Venom 5000 50c
Tried adding extra weight by taping in 2 NiMh batteries.
Any suggestions?
Maybe the boat is just not designed to run at the speeds of a brushless?
Here are the details:
Pro Boat 1500 kv motor.
Tried M445 and P220 props.
Trim tabs are 1.5 inches. Settings from level with hull to 1/8 inch down.
It is a deep V hull.
Batteries: Venom 5000 50c
Tried adding extra weight by taping in 2 NiMh batteries.
Any suggestions?
Maybe the boat is just not designed to run at the speeds of a brushless?
Comment