TWO ESCs to one Motor??

[TINY]

I have one going cheap..... Twin 120amp i read twin 240.... no good to me brand new take $50 off bens price.. free shipping.. or it will never get used...
DSC03006.JPG[/QUOTE]

[properchopper]

Would any of these work for you ? LMK

DSC03010.JPG

[Darin Jordan]

Would any of these work for you ? LMK

[ATTACH=CONFIG]70710[/ATTACH]

Tony... the pair in the lower left look to be B80 cooling plates. I was going to fab up some from copper plate this weekend. The trick is getting the controller side thick enough to support the controller properly.

Those pink ones are interesting... what are those from?

[properchopper]

Tony... the pair in the lower left look to be B80 cooling plates. I was going to fab up some from copper plate this weekend. The trick is getting the controller side thick enough to support the controller properly.

Those pink ones are interesting... what are those from?

Darin I gotta run, B Back later- The pink ones I had forever; can't remember. The LL are B80's I think. Any of these are yours if you need them. Catch you in a few hours.

[Boaterguy]

Hmmmm.....

[ATTACH=CONFIG]70707[/ATTACH]

Tony, that would have the same issues as any other two ESC's
it splits the PWM and has two IC's (this is all an "i'm pretty sure") that each read the back EMF from either motor and adjusts accordingly, probably with a piece of code tieing the two motors together but allowing a little freeplay, so it wouldn't change an issue of not letting them work together, then again, it's your 160$.