I have a prince 25 running 7xl w t180 on 4s,and it turns awful it hops like mad in corners almost enough to make it flip aroundon itself any ideas? I even tried ading trim tabs to help it a bit but stayed the same.....
prince 25 hopping
Collapse
X
-
This the one I sold ya?
The only time Ive ever had issue is with to tight of turns. Outside of that she was glued on rails!
Maybe the balance point is off?42" Osprey, 32" Pursuit, 26" Bling Rocket (rescue), Blizzard Rigger, JAE 21FE rigger, Hobby King rigger (RIP) -
I have moved cog all over the place makes no difference,maybe I am just wanting too sharp a turn at speed like my df29 does.or there is too much weight too high up like a 7xl with 4s and a larger esc than needed hmmm maybe a ul1 package would work better,it is a missile now tho jeepers.Comment
-
What KV is the 7XL? I run a PB 1500kv motor, Turnigy 60A ESC, and a single 5000mah LiPo in the middle right in front of the motor, with a X445 prop. Here is how she moves.
Comment
-
kv is 2380 area I think,I am running a grim 42x55 and a x642 and this boat was in a large pond right beside 90km/h traffic just pulling away from the cars by almost double it seemed,I gotta gps it before making things smaller electronics lol.maybe I am just trying to turn with too much speed.nice vid tho..... I may go with a ul1 setup after all for driveability and amp drawComment
-
I went down in KV and up in prop because when I was running a 3656, 2600kv motor on 4S and the boat ran like crap. I was running a x440 and even went down to an X438 and still porpoised like crazy, and turning was impossible. I would try a x440 or X438 with your setup and see if that helps.Comment
-
Comment
Comment