CC1512 2650kv DF29

[Brushless55]

would putting a CC1512 2650kv motor in a DF29 be to much on 4s ?
just getting some ideas right now, as I have this motor and wondering what it could go in..
thanks!

[Jesse J]

I suspect you would have to use a small prop, have heat issues and hi amp draw. I would not use something like that for boats over 26" personally. It would be a good candidate for a df26, or MHZ shockwave (like mine). And then it would be great on 2S with a 37ish mm prop.

[TheShaughnessy]

I think blackjack put one of those in his geico. It was ungodly fast but I think he said run time was short and the caps on his t180 were getting pretty warm if I remember correctly.

[TheShaughnessy]

http://www.youtube.com/watch?v=dpIqC...e_gdata_player.
Found this one for u. Send blackjack a message. Pretty sure he said he prefers the 1800 kv outrunner for sport running. Seems like u can get away with that motor but it will be a hotter set up. U commented on that vid brushless.

[m4a1usr]

I dont see why it wouldnt work in a mono. Like its already been said. Run a smaller then expected prop. I have one in my UL1 currently and a 40mm prop is about the limit. Plenty of power thats for sure. Great acceleration and probably right at the top of the max eff range. Sure sounds awesome!

John

[Brushless55]

yeah, lots of rpms that's fore sure!
so maybe a X440 prop?
I'm either going to put it into a 26-29" hull or sell the motor??
I wonder if it would last in the new Impulse 31...
but dang, almost 40k rpms would sound crazy!

[TheShaughnessy]

X437/3?