Anybody seen these before????

[kendt]

$(KGrHqQOKo0E33DU1bRuBOD2meRm-w~~_12.JPG

http://www.ebay.com/itm/NEW-SET-OUTBOARD-MOTOR-380-size-/130540806840?_trksid=p5197.m1374&_trkparms=algo%3DPI.WATCH%26otn%3D8%26po%3DLCA%26ps%3D63%26clkid%3D2179235520703874303

Looks very interesting.

[Boaterguy]

looks to check out, on one of the pictures it looks like the flex isn't aligned properly, may want to dig deeper.

[siberianhusky]

Thats one nice looking setup! Looks similar to the angle drive. Eventually I'll step up from the K&B lower unit.

[kendt]

I sent a message to ask what its made of. It looks like powder coated alm but cant say for sure. No reply yet but for a complete unit the price looks pretty tempting for sure.

[rcboatmanwithkids2880]

Hi Guy's ,

Looks like the unit i bought for a previous tunnel project , if you go to rcuniverse.com & look for the profile " zapco " you will find it belongs to a guy named Narade from Bang - Kok Thailand , who is a pleaseure to deal with , despite the language barrier . The unit i bought of him is made of Fibreglass , he sells the outboard leg he produces in both Fibreglass & Carbon Fibre in different sizes , at a reasonable price ......

All the best in F/E R/C Boating ,
Brad

[kendt]

I found his gallery. Very cool. He makes them in many colours and many dif sizes. Very good stuff!! I believe i'll be getting in touch with him for a drive for my hotshot .45 build. Thanks for the info!!!

[rcboatmanwithkids2880]

No worries mate , Narade is a nice guy & should be a reliable source for your outboard leg , & if you need parts he is also quite helpful in that regard as well ....

All the best in F/E R/C Boating ,

Brad

[Make-a-Wake]

Looks to be for 380 motors................wonder if there is a mount screw spacing to throw a 540 on it?

[kendt]

His post on rc universe says he makes thm in s,l, xl so im assuming that means 3.5, 7.5, 11cc versions. I will ask him to be sure.

[rcboatmanwithkids2880]

Hi Guy's ,

He has taken all the different set ups into account , so 3.5 & 7.5 & 11cc powerheads should be just bolt on . On the outboard leg i bought off Narade , i have a 540 size Feigao 8xl ....

Brad

[kendt]

My only real question is does he make one that takes the shaft from th 7.5cc version. I am putting a 4074 on it and am not sure that the 3.5 shaft will handle the power. It will be pushing a fg 35"hull.

[kendt]

I heard back from narade. all of his units use a 4mm shaft. Im not sure why the larger ones still use such a small shaft but thats what it is>>>