New Himodel marine ESC's

[ray schrauwen]

I owned one of those Pulso 70 amp esc's way back and hated it. It just got hot and smoked.

The Sunrise is the same as the new HM ICE but, again, based of YGE's design if not YGE itself.

I see what you are saying. I'll get to the bottom of it Cornel.

I'll dig up that thread...

[jkr]

Why it has 2 cables for rx?

[Alexgar]

^^^^^^^^^^^^^^^
Good question

[Jacked1]

Why it has 2 cables for rx?

One is for the programmer and one is for the receiver.

[Mel279]

One is for the programmer and one is for the receiver.

which one for the programmer and which one for the rx? I just bought one but sadly they send me the air type, so I need to waterproof it and installed a cooling plate. I've also bought the program card and I have no idea how to use it, does anyone has any idea on how to use the program card?

[ray schrauwen]

o.k. No problemo. Bastards sent you an air one too huh? Anyway...

The shorter lead is always for programming. The instructions for the cooling plate are taken from the PDF instructions on Hi-models web site. Top right of any page.

I D/L the instructions for the AIr version of the ESC and the Prog. card. This will work fine.

The cooling tubes are soldered on the edge of PCB to cool copper on PCB. Cooling plate should work too.

Still haven't used my big ones yet and the cold is rolling in....

[ray schrauwen]

esc manual... http://www.himodel.com/en/rc_manuals_url.php?id=351

prog. card manual: http://www.himodel.com/en/rc_manuals_url.php?id=342

[Mel279]

ray

thanks for the link

[Mel279]

Ray

why is it when pulling the throttle, it slowly accelerate? is it normal? and also when I hold a bit both the top and bottom left button, the left column led blinking..what setup are those for?