Tweet
Hi guys,
i' m trying to trim my MG with my new motor but it seems that it's so difficult to me.... i have tried everything...strut up, down, negative angle, positive angle
My setup is:
Neu 1518 2340kv
200 amp esc swordfish
5s2p Nanotech 4500mah 25
octura offset brackets
octura x440/3
Here is the problem
the rear part of the boat just jump out of the water (you can hear the prop screams). I tried to put the lipos as back as i can but the problem remain the same.
I want to remove the second offset bracket which is close to the water but i dont know if that fix the problem.
On 4s the problem still remain but with smaller "jumps".
Suggestions please!!!
i' m trying to trim my MG with my new motor but it seems that it's so difficult to me.... i have tried everything...strut up, down, negative angle, positive angle
My setup is:
Neu 1518 2340kv
200 amp esc swordfish
5s2p Nanotech 4500mah 25
octura offset brackets
octura x440/3
Here is the problem
the rear part of the boat just jump out of the water (you can hear the prop screams). I tried to put the lipos as back as i can but the problem remain the same.
I want to remove the second offset bracket which is close to the water but i dont know if that fix the problem.
On 4s the problem still remain but with smaller "jumps".
Suggestions please!!!