Neu 1415 backing plate hex screw size?

[natenkw]

Can someone please tell me what size hex i need to remove the backing plate off a neu 1415? Thanks.
Nate

[Boaterguy]

Do you not have a full set? it should be either .05, 1/16, 3/32 or 1/8.. I don't own any of these that's all i can say

[natenkw]

The smallest one in my set is a 1.5mm. So i was trying to find out which one I needed So i didn't have to buy a whole new set. Thanks.
Nate

[Boaterguy]

You should find one above 1.5, the standard for metric is 1.5, 1.75, 2.5, I think

[natenkw]

It's smaller than 1.5mm. I think it's a .9mm. All I can find is .7, .9, 1.3mm. Thanks.
Nate

[Boaterguy]

wow, that's small, the grub screws are usually 1/16, head screws are 3/32 or 1/8, those ae the only ones i've ever used. Strange..

[natenkw]

I know. All the motors I have are not smaller than 1.5mm. Thanks for your help Boaterguy.
Nate

[Boaterguy]

I didnt help much, but i'll take it anyways

[Alexgar]

I have a .05 I use to pull my aveox plates but there hard to find may have to order one if you can't find one I'll send it to you and send it back when your done my aveoxes were like 1412s

[natenkw]

I have a .05 I use to pull my aveox plates but there hard to find may have to order one if you can't find one I'll send it to you and send it back when your done my aveoxes were like 1412s

Thanks for the offer, but i already found one on flea bay. Thanks again.
Nate