Swordwish 200 ?

[Diesel6401]

The update from Steve is the same firmware from astek

http://forums.offshoreelectrics.com/...&postcount=107

[Steven Vaccaro]

The update from Steve is the same firmware from astek

http://forums.offshoreelectrics.com/...&postcount=107

thats the latest given to us from Hifei

[Diesel6401]

thats the latest given to us from Hifei

Thought that might help some people to see all the different codes fully typed out. I have 3 of the 200s and havent tried them yet. 2 are installed in different boats one is a spare

[Steven Vaccaro]

Thought that might help some people to see all the different codes fully typed out. I have 3 of the 200s and havent tried them yet. 2 are installed in different boats one is a spare

I hope I didnt sound like I was debating, that wasnt the point. I'm just a bit lost at this point for whats the latest. I have an email in to them to see what is the latest #.

[Diesel6401]

I hope I didnt sound like I was debating, that wasnt the point. I'm just a bit lost at this point for whats the latest. I have an email in to them to see what is the latest #.

All good..

If you and Astec both have the same verison released around similar times I would assume it's the latest out. Like I said I haven't tried mine yet, hopefully this weekend.

[Alexgar]

Mine has a delay too it's a aqst 120

[sailr]

Dang! That delay is not good for heat racing!!

[Insaniac]

I've tried both versions and the version with the last four digits as "200L" seems to have the least "delay". Not sure which version is the correct one.
Does anyone know the latest firmware version serial number? You can't always go by the date.

[keithbradley]

(assumes 100% energy transfer efficiency to ESC)

Obviously assuming a 100% energy transfer is not a reasonable representation...there is energy expelled into the water, hull, air, ect. A LOT of the energy from a moving boat never makes it back to the engine, in fact the majority of it doesnt.

[Diesel6401]

I tested my swordy out with the lastest version I have the delay.... After a few laps I did get use to it though.