4MM collet from Kintec,wrong one

[Shaun78]

The prop end is too small. where can i get a 4mm drive dog with ears that will fit a regular prop?

[G1ST]

If you want to use 3/16 props you can make a bushing out of 3/16 OD brass tube.
Steve sells the tubing or bushings pre cut
Greg

[Shaun78]

I have bushings but the 4mm drive dog prop ears are to small. I need a stock genesis drive dog.

[G1ST]

Gotcha
If Steve doesn't have a 4mm Drive Dog Ben at Fightercat does.

[Shaun78]

I just hope they have the 4mm dog with ears to fit regular octura props

[G1ST]

I see what you are saying.
I'm building a Fightercat Daytona with FC hardware. I have a X445 bolted up and the teeth of the drive dog are thinner than the notch in the prop. The teeth do go the full depth into the prop and when the prop nut is tight it doesn't move at all.
I haven't run it yet so I can't say if the fit will be a problem or not. I'm sure others have been down this road before.
We'll see.
Maiden coming soon.
Greg

[Shaun78]

I hear ya...the one on my genesis now is a perfect fit.