will this setup work for a 36'' deep vee

[MARKY C]

i would like to know will this setup work

a 36'' deep vee hull
leopard 4082 1450kv 4 pole motor
180amp turnigy esc [with etti cap board]
2x turngiy3s1p 5000 40/50c 6s in series
octrua x445 prop.

what sort of speeds would i be looking at??

[LarrysDrifter]

A Leopard 2084?If thats a 20mm diameter can,thats smaller than a 380 I believe.Id run a 4082 Leopard.

[MARKY C]

sorry my mistake i meant a 4082

[LarrysDrifter]

I have the same set up in my 33"mono except my motor is the 1500kv version.It runs low 50's so far.Still needs some tuning-hoping for mid 50's.
Your hull being slightly larger,Id say right around 50mph.I know the 4082's can swing a pretty decent prop,but it depends on the hull too.

[Diesel6401]

Steve's got that new 4082 2200kv leopard, I wouldn't mind trying that motor on a hull this size on 4s2p. http://www.offshoreelectrics.com/pro...o-4082&cat=148