Genesis twin 6xl setup

[RFOUNTAINIII]

I RECENTLY PURCHASED A GENESIS TWIN WITH 3674 2770kv 6xl motors! LOOKING FOR ADVICE ON ESC AND LIPOS TO USE! THINKING 120 OR 180 ESC AND SOME 6S 5000MAH 40C LIPOS! ANY ADVICE ON SETUP AND WHAT TO USE WOULD BE GREATLY APPREACIATED!

[Brushless01]

Id run 3s per motor !!

[Doby]

Was that the E-Bay Genesis........6S on a 6xl motor= if that what the original owner was running, I suspect the motors could be stressed and not have much life left in them.

[RFOUNTAINIII]

I am shootn for 70 plus and 3s wont get me there i dont think!

[Doby]

Are you looking just to do SAW running (one or two passes over a few seconds each) or trying to get some decent run time as well?

[RFOUNTAINIII]

I want to do both! I have some 4s witch i wanted to do most running with, hopefully high 50 to low 60! And then the 6s for saw runs hopefully touch 70! What r thoughts? Should i remove the motors and run something different?

[b.mcdaniel.2009]

I want to do both! I have some 4s witch i wanted to do most running with, hopefully high 50 to low 60! And then the 6s for saw runs hopefully touch 70! What r thoughts? Should i remove the motors and run something different?

Twin 10xl's or two Leopard 4082 1500kv on 5-6s each should do the trick. Just FYI, the Genesis doesn't like anything over 65mph, around 70mph they take flight, how do i know,..... It happened to me with a single Castle 1717, T-180 on 6s and a x 645 prop.

[keithbradley]

Here ya go...this guy has some awesome setups, and is using affordable components!:

http://www.youtube.com/watch?v=o3KCKjPuZkc

I would copy him. I havent seen it done better yet.

[Brushless55]

I am shootn for 70 plus and 3s wont get me there i dont think!

I can do 60mph on 4s in my Revo
but running more than 4s on those motors in a boat, could be asking for smoke
and I would think SAW only?

[Dangerous_Toys]

If my calcs are right, 6s on those motors is 61494 rpm's. Those motors will . I would have to agree with Brad and go with the 10XL or the Leopards. JMO

[Rumdog]

lol.

[RFOUNTAINIII]

I want to get some run time on it before i start upgradeing! From what im hearing 6s is out of the question! Do i need to stick to 4s or would i be ok with 5s?

[Doby]

4S will be pushing 40,000 RPM.......those are really 3S Motors.

[Brushless55]

I want to get some run time on it before i start upgradeing! From what im hearing 6s is out of the question! Do i need to stick to 4s or would i be ok with 5s?

Start with 3s

[LarrysDrifter]

Are you the Legendary Reggie Fountains grandson?If so,thats awesome!!!!!!!!!!!!!!!!!!!!!!