Engine

[kal1b3r]

i am currently looking for a nitro engine or a 2 stroke engine for my other boat. does anyone have any suggestions on which one to get, so far all i found was this.

http://www.rcplanet.com/ProductDetai...Show=TechSpecs


specs if link doesnt work for you, or you dont want to go on the site:
Displacement: 0.2 cu in (3.46cc)
Bore: 0.65" (16.6mm)
Stroke: 0.63" (16mm)
Practical RPM Range: 3000-40,000
Power Output: 2.5 hp @ 33,000 RPM
Weight: 12oz (340g)
Distance between mounting holes same side: 0.83" (21mm)
Distance between mounting holes opposite side: 1.4" (37mm)
Distance from exhaust center to mounting flange bottom: 1.1" (27.5mm)
Width not including mounting flanges: 1.2" (30.8mm)
Width including mounting flanges: 1.8" (45mm)
Height bottom of crankcase to top of intake: 3.5" (89.1mm)
Height bottom of mounting flanges to top of intake: 2.9" (73.6mm)
Length from backplate to end of crankshaft: 3.4" (87mm)
Length from backplate to flywheel: 2.5" (65mm)
Length from crankcase center to flywheel: 1.7" (44mm)
NEEDLE SETTINGS: -High Speed Needle: 1.5 turns OUT from fully closed position per page 20 of manual
-Mixture Control Screw: Refer to sketch on page 17 of manual.
This screw can only be turned 90° either way.

[ReddyWatts]

Check this one. I bought one of these for a Mean Machine hull. Do not have it installed yet.

http://cgi.ebay.com/DYNAMITE-32-Marine-Inboard-Engine-DYN6450-FREE-SHIP_W0QQitemZ300141411006QQihZ020QQcategoryZ116075QQtcZphotoQQcmdZViewItem

Exhaust / parts for the 32 engine. (Click on parts list)

http://h1071118.hobbyshopnow.com/products/description.asp?prod=PRB2750