hardware recommendations

[08gtrking]

I need help picking hardware for my 36 inch cat it going to be running 1090kv motor on 8s.thank you ahead of time.

[sailr]

Is that the new Leopard 5692? That's a LOT of motor for a 36" boat! I usually stick with Speedmaster hardware from OSE. The quality is outstanding and the prices are more than fair.

[08gtrking]

Is that the new Leopard 5692? That's a LOT of motor for a 36" boat! I usually stick with Speedmaster hardware from OSE. The quality is outstanding and the prices are more than fair.

It`s actually 38 but the extra two inchs are on the tip so i don`t think it matters and i picked that motor to go 65+mph what you think ? i was thinking this http://www.offshoreelectrics.com/pro...prod=ose-80085 but sence he is out of stock i think ill have to go with this

http://cgi.ebay.com/Rudder-strut-1-4-cable-combo-23-26cc-rc-boat-/130342528087?cmd=ViewItem&pt=Radio_Control_Parts_Accessories&hash=item1e59052457

[skellyo]

For my Aeromarine Sprint Cat (34"), it was recommended to buy a Speedmaster 3/16" XTD strut, round bottom. For the rudder, a Speedmaster .40 rudder with the proper setback to correspond to the XTD strut. I would imagine you don't want to go any smaller than that on a 38" cat and both of the items you linked are smaller.

[08gtrking]

For my Aeromarine Sprint Cat (34"), it was recommended to buy a Speedmaster 3/16" XTD strut, round bottom. For the rudder, a Speedmaster .40 rudder with the proper setback to correspond to the XTD strut. I would imagine you don't want to go any smaller than that on a 38" cat and both of the items you linked are smaller.

can anyone please point me to the right direction i don`t know anything about hardware i would really like double water pick up ruder that would be a plus.thank you in advance.

[ozzie-crawl]

not sure on how the rear of your hull is (extension or not)

[08gtrking]

not sure on how the rear of your hull is (extension or not)

The tunnel is 31inchs and is inward and has 1and 1/2 inchs surface to put hardware on

[ozzie-crawl]

you could use one of these,for the rudder http://www.offshoreelectrics.com/pro...ckets+%26+More
set back will depend on strut length, one of these should be okay (mono round bottom) http://www.offshoreelectrics.com/pro...d=ros-21-strut

you could go the larger twin water pickup rudder and trim the length as well