new aquacraft tunnel topspeed3

[Jeepers]

I do like, however, that the "Stiletto" in the pic has the inside line though the corner... :D

Thats because the "TS3" is passing the "Stiletto" on the outside!

[raptor347]

Either boat will be competitive once set up properly.

I've run both hulls. The VS1 is fantastic as long as the conditions are good. The TS3 is better in rough water. BTW the TS3 won spec OPC at the 2008 FE nats (I had a prototype).

The TS3 and TS2 have nothing in common.

[Darin Jordan]

Thats because the "TS3" is passing the "Stiletto" on the outside!

UMPH!!!!

NICELY PLAYED, Sir!!!!

[v-spec]

I've seen the TS-3's run as Nitro boats and they seem to work very well.

I personally do NOT think the TS-3 is ugly or looks bad in ANY way... it looks GREAT...

I partially think this because I like stuff that looks like REAL boats, and, as you'll see in the picture attached... The Stiletto AND the TS-3 should look right at home together on the water!

I just wish that Mikey would hurry up and get an FE version DONE!! Looking forward to many water-bound battles!!

I do like, however, that the "Stiletto" in the pic has the inside line though the corner... :D

I've never really cared for tunnel hulls but that pic is great! It's my new desktop background, (hope you don't mind)

[Darin Jordan]

I've never really cared for tunnel hulls but that pic is great! It's my new desktop background, (hope you don't mind)

Just found it on the internet, so I hope whoever took it doesn't mind...

I never cared for tunnels either, until I ran one... Now I'm hooked! They are quite a bit of fun and challenge to drive and race.

[Jeepers]

UMPH!!!!

NICELY PLAYED, Sir!!!!

or the driver just sucks on the TS3