Ammo Motor settings?

[JimClark]

I am no longer on RR so I will be hanging out more here.
Got a question about programming a Hacker Navy 70 for a Ammo motor.

Getting ready to test the 1/16th scale hydro with the Ammo 2845-3600KV motor and 2s lipo and a 6 cell sub c pack as well as a brushed motor 12 turn car motor and the same batteries. I have a Hacker Navy 70 ESC and I am trying to figure out what program settings to use for the Ammo for the following.

For the Timing mode here are my choices
1 (2-5 degrees) for Hacker motors
2 (10 degrees) for Aveox and astro motors
3 (18 Degrees) for mega, pletts
4 (30 degrees)


Frequency of the controller choices are
Mode 1 (8 kHz)
Mode 2 (16 kHz)
Mode 3 (32kHz)

The rest I can figure out.
Thanks
Jim

[Jeepers]

interesting I will be following this thread!

[Steven Vaccaro]

Jim how many poles do the smaller 28mm cans have?

[JimClark]

Steve I am totally ignorant on Brushless how do I tell by looking at it?
Jim

Jim how many poles do the smaller 28mm cans have?

[Steven Vaccaro]

I'm not exactly sure how to. You can probably mark the shaft and rotate it to count the poles. But I'm not 100% sure. Is it smooth or does it cog when you rotate the shaft by hand?

[JimClark]

Totally smooth

[Steven Vaccaro]

probably 2 pole. I looked over the manual and there isnt much there. I would ask Great planes this question.