brushless Outboard on a V hull

[ON THE FARM]

I have a brushless outboard set-up that i am mounting on a 34" test v-hull.
i have never mounted an outboard to a v-hull, so if you have done this can you guru's give me some advice?
do i set it up so the cavitation plate is level with the bottom of the hull (lowest part of the V)?
i know on a tunnel hull i have always set them up about 1/8"+/- above the lowest edge of the sponson.
anyone have any tips and or tricks?

THANKS

[Eodman]

Check out the "pdf" on Aquacrafts site for the EP1 outboard if I remember right there's a diagram on mounting location of the outboard.

It will give you a starting point!