Esc cutting on and off

[ezhitz]

Tried my new SeaKing 120 amp in my rigger today and it would cut in and out.
Sometimes I would go a lap or two then cut out or just throw it in and go a couple of feet and stop.If i would wait a minute then it would go again. The temps where never above 105f I'm running a 7S feigao timing is set at 7.50 degrees and the lvc is 3.4v/cell.i did manage a couple of gps readings today.

[LiPo Power]

Is it cutting ussually when full throttle?

[ezhitz]

yes it is or if its already stop when i wait then give it throttle it will come up on
plane and stop againhttp://www.youtube.com/watch?v=REitCZmOtjc.Heres a little clip where its was running and died coming out of the corner.

[LiPo Power]

I had this going on on my UL-1....
Could not find the reason for cutting off on me...
The problem was...... CAPS!!!!
Went to my little shop and installed more caps. Result , no more cutting off and on.....
I am not saying this is your problem in your case but it was with my ESC. Look in to it. Maybe it is as easy as adding new caps....
Robert

PS
Read here:
http://forums.offshoreelectrics.com/...ead.php?t=9828

[ezhitz]

Thanks LiPo I will look into that it won't hurt to add one plus my son
puffed two on his turnigy 180 we nead to repace also.
Thanks

[LiPo Power]

What set up was the Turnigy 180 running?
Thanks
Robert
PS
Where are you in Ontario?

Thanks LiPo I will look into that it won't hurt to add one plus my son
puffed two on his turnigy 180 we nead to repace also.
Thanks

[ezhitz]

In brampton, He running a 7Xl on 4S with a X440 in Osborn Miss Supertest
30" hydro. A lot of on/off and half throttle running to keep it on the water.

[Raydee]

Did you try turning off the low voltage cutoff? I read before about that controller having a problem with that.

[Xfactor]

Check for solid connections, bullets etc.