top speed 2 handling

[ishamblen]

hi great forum,i have a top speed 2 with a black jack motor turnigy 4s 5000 35-45c i tryed ax445 and m440 and m442 props.runs great on straight no turns it wants to spin out.i tryed raiseing and lowing the motor and adjusting the angle.no help it has a fuller lower unit.any help would be great. THANKS

Irving

[JimClark]

how bout adjusting your servo travel?

[ishamblen]

we readjusted the servo travel.i readjusted the pushrods to a different hole on servo arm now i have to take it back out to try.
THANKS Irving

[Doby]

Do you have the 2 "recovery pads" installed ?

[eboat]

I had to turn the steering way down on mine and it worked great
It was like once you got past the point of no return it was too late and it would just spin out

[ishamblen]

I do have the 2 recovery pads installed

[ishamblen]

i am using a futaba 3pm-x radio

[properchopper]

I had to turn the steering way down on mine and it worked great
It was like once you got past the point of no return it was too late and it would just spin out

Exactly !

[D. Newland]

Are you driving WOT into the turn? If so, try dropping your speed just a hair before the turn, make the turn, then accelerate out of it.

I will say that my TS-2 turned much better when I replaced the REK for the Hyperformance drive. The skeg is much bigger.

[sailr]

sounds like you might be a bit nose heavy too! Move the batts back if you can.

[ishamblen]

I can slow down on turns the same.the left sponson wants to lift to much.i cant move the batts any further back.going to try adjust the steering speed some.

Irving