Ordering parts Need help

[Jeff Wohlt]

Getting ready to order some stuff from Hobby City and want to get a decent UBEC and also looking for something to charge cells off my Shultze charger with a balancer built in. Someone had some board that looked like it would charge several packs at once.

Thanks for any help.

[ksm2001]

Here are the ones I use but they are sold by Himodel, I wish Hobby City would sell these, you may have to mod the plugs to fit your charger though, I use an Icharger so the plugs fit. also depends on which batteries you have since the balance plugs aren't the same. this way you can charge in series or parallel.

http://www.himodel.com/electric/Multi-adapter_Balance_Harness_2S-10S_TP_CONNECTOR_for_Charger_1010B.html

http://www.himodel.com/electric/Multi-adapter_Balance_Harness_2S-10S_TP_CONNECTOR_for_Charger_1010B.html

http://www.himodel.com/electric/Multi-adapter_Balance_Harness_2S-6S_Polyquest_Hyperion_Connector_for_Charger_1010B.html

The Kokam/Graupner board will also fit the Himodel/Align balance plugs.

as for the Ubec I use this one for my boats with no problems up to 5s.

http://www.hobbycity.com/hobbyking/store/uh_viewItem.asp?idProduct=4319&Product_Name=TURNIGY_3A_UBEC_w/_Noise_Reduction

Use this one if your using above 5s.

http://www.hobbycity.com/hobbyking/store/uh_viewItem.asp?idProduct=6320&Product_Name=TURNIGY_5-7.5A___%288~42v%29_HV_UBEC_for_Lipoly

[Jeff Wohlt]

Thanks, that was the ubec I was looking at. I will check out the himodel adapters. I run turnigy lopos for the most part.