Proboat Hydro Brushless

[wickedgmc]

Well I scored a new Budweiser pro boat hull and it is just screaming to be converted into a brushless. I already have and esc for it as well as all the Twisted Liquid Racing hardware my biggest question would be motor.

Feagio S,L or XL or maybe a different motor. I will probably run 2s lipos in it if that helps any


thanks

[Jeepers]

Go with a the XL motor.

[wickedgmc]

easy enough, I have a 7,8,9,11 and a 13XL which one?

[saleens7]

only 2s lipo? well maybe if you ran the same NEU motor darin ran in his SV27 2s2p setup you could probably get good performance, but i would think you should run atleast 3s in that...

[wickedgmc]

lipos as in more than one, Sorry for that it will end up 4s total

[saleens7]

oh....in that case, a 7,8, or 9XL would be good....

[Jeepers]

that boat is 28"right?

an 8XL on 4s m440 prop would move it decent.

[wickedgmc]

that boat is 28"right?

an 8XL on 4s m440 prop would move it decent.

you are correct about the 28". I will wait for the mount and have it in the water by the end of this week

[NorthernBoater]

How heavy is the bare hull compared with other hulls. I would say for just sport running go with either the 9XL or 8XL. What brand are the LiPos you have?

[wickedgmc]

I will have to weigh the hull to see how much it weighs. As far as lipo's I have some max amps at the moment. I am going to get in on some TPX cells in the next few weeks.

[hkusp45]

I think the Miss Bud will be a tight fit. Not a whole lot of room in that hull!