Ball thrust bearing vs teflon washer

**Jeff Wohlt** · 12-14-2009, 10:30 AM

Yes.... and still leaving 3-4mm between the drive dog and strut.

**KTM_EXC** · 12-14-2009, 10:43 AM

Jeff,
thanks for your reply.

As I am a very newbie of FE is there anybody that have an image of how to do the correct work?

Thanks again
Andrea

**Alfa Spirit** · 12-14-2009, 04:33 PM

The part of flex in the shaft is squared and the shaft can' t move in the strut, only 1mm

**D&D** · 12-14-2009, 05:06 PM

Originally posted by Alfa Spirit

The part of flex in the shaft is squared and the shaft can' t move in the strut, only 1mm

Where did you find this square drive ferrell? I've only seen the square drive nut at the motor before..

**Steven Vaccaro** · 12-14-2009, 08:37 PM

I havent seen a square drive nut.

The strut in the picture is part of the stuff coming out of Asia these days,

**Alfa Spirit** · 12-15-2009, 04:19 PM

This is a HOTR aluminum rudder and strut with a Graupner 3/16" adapter

I will change the Graupner DD with a MBP Racing model

Comment