Air Scoops for scale 32"

[tomstoys2]

Does anyone know of any Air Scoops other than the ones MHZ sells? I need 2 that look similar to the ones on this Skater. I'm going to put them on a HOR cat.

I doubt there is anything that matches that's not custom so plan B is to build/carve them. Other than a block of pine and some whittling, any other suggestions?
I saw a post from a few years ago where Graham "Carved" out a couple for pine.
Thanks,
Tom

[Jeff Wohlt]

If you want them to have back cuts or back lower edges you will have to carve them. Only other is molding halves and then joining them. They should not be hard to do draw the profile then get after it. Cover them with some resin or epoxy and paint them.

[tomstoys2]

Thanks Jeff,
I figured carving would be the way to go.