Triton cat hull question

[goldswim5]

Alright guys I've been lurking here for a while, I think this is my first thread. But I was wondering about an old plastic Academy Triton cat hull that I've had for a few years now, would it be worth it to go brushless in it? I was thinking just a HobbyCity setup, with OSE hardware. Will the hull hold up to it, or would I be better off going with a fiberglass one off the bat?

Something like this setup on a 2-3 cell LiPo. Not sure too if that's the best cheapie ESC for this motor, would love some advice on that one.
Hardware - http://www.offshoreelectrics.com/pro...prod=ose-80085
Motor - http://www.hobbycity.com/hobbycity/s...hless_Inrunner
ESC - http://www.hobbycity.com/hobbycity/s...es_90-100A_ESC

[Steven Vaccaro]

Its a cool looking boat. If you have the hull, you can always build it, than swap everything in the future.