sentilon 100HV prog ??

[cacofonix]

hi there

i try to setup 2 Sentilon 100HV (ver4 with 2 cables)
i think i will kill someone by the end of the day .....

i have the prog card (plastic white)

first esc : ok i can change parameters with card

second one ........ there is a BIP every 2 seconds, card led are ok
i can change set up on card, BUT when pushing OK ..... blue led start flashing
and ..... still flashing after 2 hours

do someone succeed to setup this ESC ???

thanks

herve

[txboatpilot]

hi there
i try to setup 2 Sentilon 100HV (ver4 with 2 cables)
i think i will kill someone by the end of the day .....
i have the prog card (plastic white)
first esc : ok i can change parameters with card
second one ........ there is a BIP every 2 seconds, card led are ok
i can change set up on card, BUT when pushing OK ..... blue led start flashing
and ..... still flashing after 2 hours
do someone succeed to setup this ESC ???
thanks
herve

Sounds like the esc is not excepting the program... I have used these before and the blue led always stays solid after complete...

[cacofonix]

so

few minutes ago i succeed to setup throttle range on first ESC and second one also ...................
but when i try to modify second one setup .....same

seems i have to try with emitter

herve

[Flying Scotsman]

Switch the ESC's and see if you get the same problem with the suspect ESC on the same boat.

Douggie

[cacofonix]

no no, both are on same boat, it's a special mono hull : 1.25m lenght, 0.24m width
setup is:
2 MEGA 22/45/2
2 Sentilon 100HV
2 rhino 5S 4900

2 Zdrive (home made) with L+R propeller

so i need to have same setup on both esc .....

herve

[Flying Scotsman]

OK, are you programing the ESC for each motor and total battery load ?

Douggie

[cacofonix]

no each motor have is own esc and lipo
i think there is a problem with the second esc, i check soldering, prog cable .....don't see anything particular
i hope i can change setup with emitter, if not ..... i have to order a new one.

i "just" need to change cutoff / timing / nb of cell ...........

herve

[cacofonix]

hi folks

after many trial, i finally try to setup esc with emitter : OK !!!
so it's ok for next run.

but with plastic card i still can not modify any parameter.

herve