Motor and Servo for 1/8 Scale Budweiser T4 Hydro

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Turbotunnel
    Junior Member
    • Feb 2010
    • 12
    #1

    Motor and Servo for 1/8 Scale Budweiser T4 Hydro

    What rudder servo and electric motor would someone recommend to make a 1/8 Scale Budweiser run really well.
    Tunnel AirBoat Build
    Latest is H&M SPyder Triple WIng Build
    T4 Laser Cut Build
    Tags: None
    • ron1950
      Fast Electric Addict!
      • Aug 2010
      • 3024
      #2
      a 10s set up would hull butt with a castle 2028 .....servo wise its a toss up...depends on how much u want to spend
      MY RETIREMENT PLAN?????.....POWERBALL
      74 vintage kirby clasic hydro, pursuit mono, mg, 47'' mono, popeye hydro...

        Comment

        • Turbotunnel
          Junior Member
          • Feb 2010
          • 12
          #3
          How about the MHZ 4035/1260 motor with 8S setup. I was looking at spending about $80-100 on the servo. I wasn't sure how much torque I need.
          Tunnel AirBoat Build
          Latest is H&M SPyder Triple WIng Build
          T4 Laser Cut Build

            Comment

            Previous template Next
            Working...