Ok here’s what I’ve got. Twin Merc type subsurface drives with an adjustable trim. Two winch servos and this stupid radio. I love and hate it.
Ultimately what I want is this. Either a button or a dial to move the drives from Low/Mid/High position. I don’t care how it’s done I just can’t figure out how to do it. Even if it?s a dial that I have to go one way for up and one way for down.
I’ve tried messing around with a Y harness for both servos and then setting up “steps” but that hasn’t done it.
The other issue is I can’t get the servos to move at the same rate. They are Reef’s RC servos and I sent the first set back because they were so off. They got me a set that is better but I’ve never had a set of servos of the same mfg and same model not move in unison.
I’ve tried multiple other servos, ESC’s and power sources. All other servos move exactly the same....these will not.
Anyway. Problem one is setting up the radio to do a 3 step thing. Anyone have some ideas for me?
Thanks in advance,
Mike
Ultimately what I want is this. Either a button or a dial to move the drives from Low/Mid/High position. I don’t care how it’s done I just can’t figure out how to do it. Even if it?s a dial that I have to go one way for up and one way for down.
I’ve tried messing around with a Y harness for both servos and then setting up “steps” but that hasn’t done it.
The other issue is I can’t get the servos to move at the same rate. They are Reef’s RC servos and I sent the first set back because they were so off. They got me a set that is better but I’ve never had a set of servos of the same mfg and same model not move in unison.
I’ve tried multiple other servos, ESC’s and power sources. All other servos move exactly the same....these will not.
Anyway. Problem one is setting up the radio to do a 3 step thing. Anyone have some ideas for me?
Thanks in advance,
Mike