TS3 radio box mounting...suggestions?

[capnswanny]

So I'm finishing up the box for my ts3, I was planning to use 3M double sided tape to hold it down, same tape I use to hold the rear sponsons on my rigger, is this a good idea? I know I'm a bit behind the times for new builds, but I'm looking forward to seeing this hull carving the lake! Thanks! Corey

[Diegoboy]

Does your box need to be removable? Exactly what 3M tape are you talking about? The foam mounting tape or the grey putty-like tape used to mount car emblems?

[capnswanny]

The grey putty like tape....cut it of with a guitar string type stuff. I just like the idea of possible remove...

[Diegoboy]

If it must be removable, that's what I would use!

[capnswanny]

Thanks!

[capnswanny]

Would you advise against removable? I would certainly epoxy it in if there were gains from it.
Thanks again for your advice.

[properchopper]

Corey , Once upon a time I has two TS-2's where I could transfer the box between them. Might give this concept a thought :

DSC00731.JPG DSC00732.JPG [ATTACH=CONFIG]80134


[/ATTACH]DSC00735.JPG


I've found that for many applications tape works well but after it gets wet (as it will in the TS-3) it loses it's gripping power.

[capnswanny]

I like it! Thanks for the pictures....a thousand words!
Perfect option for me since I over cut a bit aft, wood will fill it on nicely!