Plettenbergs new motor

[Punisher 67]

Have a look at this bad boy , 100mm x 71mm of brute torque.........................

http://www.plettenberg-motoren.com/german/Motoren/Brushless/Teras_50/Motor.htm

[Jeff Wohlt]

guulllp...is that a 12mm shaft

[Ub Hauled]

guulllp...is that a 12mm shaft

Comes with a coupler though!

[EPower]

All 370 BM series have 12mm output shaft

[Punisher 67]

These motors are about 20% larger than the already huge 370 series , they come in two KV's 735 and 1080 and use 10C to 14C lipo's

[EPower]

Yeah most impressive motors i own an HP 370BM/50/A1-S this new motor will be hard to beat 6 to 8 kilowatts of power
I think you meant to say 10 to 14 S not 10 to 14 C

Cheers Adrian

[Punisher 67]

10 to 14 cells but yes , I don't know why they go S when cells spell with a C

[Ub Hauled]

it referes to 10 in Series not to the word "cells".

[EPower]

it referes to 10 in Series not to the word "cells".

Ok Then

[Punisher 67]

Adrian I used to have two 370's a A1s and a A2s that I sold to a fellow in new Zealand about a year ago........................

Are you that fellow.......................

[EPower]

Hi there that will be Merv he's one of the first guys to get into the FE here in NZ i got the bug from him
BTW i'm very impressed with your boat what a rocket i hope mine goes as good what size prop are you running in that beast ?

Cheers Adrian

[Punisher 67]

Hello Adrian

a ABC 2616/3, and a Prather 265/2 , I have gotten up to a little over 112Km with the Prather on 12C and 109km with the ABC on 10C

[EPower]

Hi there thanks for that those are large props i was told to run x455 or x457 on my setup what motor are you using ?

[Punisher 67]

Hello Adrian

A Neu 2230/1Y in the video but I have mellowed the stealth out a bit with the 2230/1.5Y but have yet to run it on 12C with the ABC 2616 I am hoping close to 100 kph . The Sniper build will be the wild card this year , I have put the 2230/1Y in that hull and have a Lehner 3080/7 waiting on the shelf when I decide to turn it up a notch..................

[Punisher 67]

This is another motor the will easily rival the neu 1527 in power and size and more than likely cost , it is however in the Neu1527 and Lehner 2280 ballpark . they have yet to make it a water jacket but i'm sure its in the making . also comes with 8 mill shaft

http://www.plettenberg-motoren.com/german/Motoren/Brushless/Dinator_70/motor.htm