TP POWER 5670 Rear Endbell removal

[DAVEKAN]

I would like to put ceramic bearings in this and it seams that it may be glued in. I did remove the stickers, and the 3 small set screws, and may have to put it in a press to get it off.
I do have the capability to make a new end bell, but prefer to use the one that came with it if I can.
Anyways how have any of you done this.

Thanks Dave

[Peter A]

Try a bit of heat, not too much, to soften the glue.

[DAVEKAN]

Hello Peter, Thanks for that. Perhaps I will make a small puller, but there is not much meat there, and the end turns are very close the the inside of the end bell.

Dave