Rail mount for Lehner 22 series ??

[Kaotic]

I've done a lot of searching on here for rail mounts, but it seems there where some really good guys making them but have closed up shop.

Any suggestions on where I might be able to pick up a 4" or smaller mount that would fit a LMT 22 series motor?

Thanks!

[Kaotic]

Well I talked to David at HRC and he said he could make one up for me, so I'm going to do a little more researching and see what else I can find. Good thing is I'm in no rush.

[Rocstar]

No rush? You only have 171 days to build, test and tune. Of which, most of those days the water will probably be in a solid state.... Better get a move on.

[ron1950]

dave can make you almost anything u need and its allot cheeper then some other places when they were open for buisness

[Kaotic]

No rush? You only have 171 days to build, test and tune. Of which, most of those days the water will probably be in a solid state.... Better get a move on.

You're right! Efforts must be doubled!

[Kaotic]

dave can make you almost anything u need and its allot cheeper then some other places when they were open for buisness

Yeah I was expecting him to tell me it was going to cost a ton, but I found the price to be very resonable.