Best prop for a 1500 kv 4082 turnigy motor and t-180 esc.

[shartinspartin]

Im wanting to know the best prop to put on this combo. (pushin a 36 inch abs deep v hull)

Thanks

[greenblast]

no to be offensive> your question is equivalent to how much is a car by the pound. be specific you will find your answer

[shartinspartin]

I dont want to be too specific because my sub forum is dead... but its a spartan

[Heaving Earth]

645


Sent from my iPhone using Tapatalk

[lenny]

What prop do you have on hand and what connectors are you using ?

You should be running 5.5 bullets all the way in the setup.

I would try a three blade it should help control with torque roll in that hull,
Some props that I would try are a x646/3 and a x447/3 and so on.
Do some test runs for 1 1/2 minutes and check temps on everything and motor connectors to,
Also if you have a gps get some speed readings to.

[shartinspartin]

5.5 mm bullets. from what Ive read nobody has had luck with 3 blade props on this boat.

[785boats]

Although you haven't stated it, I assume that you are running 6s packs?
If so, then a Prather S215 works very well.

[shartinspartin]

yes 6s. Well thats good because I hace a prather 215 =)

Is this prop more pitch than stock?

[4sdash]

im running a 642 on my spartan