SeaKing 120A ESC Flashing RED!!!

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • djmaincheese
    Senior Member
    • Dec 2010
    • 347

    #1

    SeaKing 120A ESC Flashing RED!!!

    I believe I have tried everything I can but I can't get my SeaKing 120A ESC to stop flashing RED and beeping every second.
    I plug in the ESC while holding the throttle to the full position and I am able to program all the values..

    Running Mode..
    Cell Count..
    Low Voltage Cut Off..
    Timing..

    I get to the end of programming and unplug the batteries to store my selection but when I go to plug them back in it just starts beeping again.
    Anybody else have issues like this?
    Should I get the programming card?

    Any help would be greatly appreciated
  • Make-a-Wake
    FE Rules!
    • Nov 2009
    • 5557

    #2
    To store your selection you have to pull full throttle til it beeps then move throttle to neutral, not just unplug the batts.

    Is your throttle trim set to Neutral? If its set to a bit of forward it may be beeping due to that. A quick vid of you setting it up would help if possible..........i have a bunch of 'em and can program them in about 20 sec.
    NEED PARALLEL CONNECTORS?? QUALITY 5.5MM, 8MM, 8 AND 10 AWG, GET THEM HERE: http://forums.offshoreelectrics.com/...est!&highlight=

    Comment

    • Brushless55
      Creator
      • Oct 2008
      • 9488

      #3
      Originally posted by Make-a-Wake
      To store your selection you have to pull full throttle til it beeps then move throttle to neutral, not just unplug the batts.

      Is your throttle trim set to Neutral? If its set to a bit of forward it may be beeping due to that. A quick vid of you setting it up would help if possible..........i have a bunch of 'em and can program them in about 20 sec.
      .NAMBA20...Caterpillar UL-1, P-Spec OM29, P-Mono DF33, P-Spec JAE, Aussie 33" Hydro-LSH, Sprintcat CC2028 on 8s, PT SS45 Q Hydro, PS295 UL-1 power, OSE Brothers Outlaw QMono 4-sale, Rio 51z CC2028 on 8s

      Comment

      • Make-a-Wake
        FE Rules!
        • Nov 2009
        • 5557

        #4
        He fixed it.
        NEED PARALLEL CONNECTORS?? QUALITY 5.5MM, 8MM, 8 AND 10 AWG, GET THEM HERE: http://forums.offshoreelectrics.com/...est!&highlight=

        Comment

        Working...