hobbywing 80a hv esc how do you program it?

[onegreenray]

ok noob questions, esc has two receiver wire one long one short, which do you use to program the esc? i have the hobby wing boat program card using an external 4aa battery pack to power the esc and program card i can't get the esc to program?

thx guys

[JimClark]

what it didn't come with any documentation?

[Make-a-Wake]

I have one...............the long wire goes to the reciever. I just programmed mine with my Radio based on the beeps. It took a bit to figure out since it works just a bit different than the 120a.

Jim, it actually doesnt tell you squat in the instructions.

[britscoot]

connect the long wire to the program card first then connect power to the program card.
It might take a few seconds until the card lights up.

[JimClark]

Just one of the reasons I prefer to buy form other sources
Hard to be sarcastic in a forum
Jim

I have one...............the long wire goes to the reciever. I just programmed mine with my Radio based on the beeps. It took a bit to figure out since it works just a bit different than the 120a.

Jim, it actually doesnt tell you squat in the instructions.

[FighterCat57]

If you use the Programming card, make sure you use the marine faceplate. Otherwise the options won't match.

http://www.hobbywing.com/english/ArticleShow.asp?ArticleID=435

Programming:

http://www.hobbywing.com/english/ArticleShow.asp?ArticleID=453

[onegreenray]

i read the half English instruction better and saw the note 4 in them, thank you for the replies guys.