Swordfish 220A-6S ESC problems ?

[Andris Golts]

Hi all plugged in 4s lipo got several quit beeps but the motor would not turn on! The TX im using is the Spektrum DX3S . What other parameters can i check ? Im at a loss at what to do. Regards Andris Golts.

[Michlee]

Board Transmitter
1st: Connect ESC to motor, plug receiver lead of ESC to throttle channel of RX.
2nd: Push joystick of transmitter to max throttle position, power on TX.
4th:
In the following, motor will emit four long beeps in flat tones.
After any one beep of the four long beeps, pull joystick to
zero immediately.
3rd:
Power on receiver, connect ESC to battery. Motor emits three beeps in drop
tones.
Then motor emits two beeps in up tones.
5th:
Calibrating is completed, it’s ready to go.

[ray schrauwen]

After calibration, please shut down RX, and unplug main pack from esc, reconnect, turn it all back on, wait for an initialization beep and test throttle and steering.