Swordfish 240 Pro

[circus162]

Finally finished my winter build. 54" Fountain, Leo 5698 2y 910Kv, plan to run on 8s. 10000mAh. Swordfish Pro II 240A.
The problem is with the esc. It will run om 4s - 6s but anything higher it just clogs.
I've tried reprogamming, setting cell count to 8, setting cell count to auto. Same thing.
The esc will count out the correct number of cells and arm, but I only get one clog out of the motor every time I pull the trigger.

Thanks,
Rich

[iridebikes247]

Try jiggling the motor wires while doing this see if it goes away after several attempts.

---Trying but this is a tough one. I used to set everything to auto with this esc and just WOT. Did you try resetting the esc with the throttle trigger? also another thing to think of.

Hopefully someone can offer help on this one, is there anyway you can get a small video if it and send it to youtube or perhaps an email?